AAC production line (Shanghai Tianjin Machinery)

AAC production line of STM Brick cutteris one kind of AAC brick cutting machine: The tilting hangeringthe mould turns 90 degree in air ,demoulds the blank and puts it on the cutting table togetherwith the side plate.The blank on the cutting tables is cut by the longitudinal cutting device through the motor and its own running. After completion and running at the pause position,the blank is cut horizontally by the motor to the center of the blank,Then cross cutting holder drops and cuts vertically from up to down until it is reset upward. Main Technical Date: 1.Production capacity ,50,000-150,000m3/year. 2.Size of blank,4*1.2*0.6M(net) 3.Cutting module ,vertical cutting is 5mm,cross cutting is 10mm. 4.Cutting precision ,length is ±3mm,width is ±1.5mm,height is ±1.5mm. 5.Production cycle,5min/module. 6.Quality of host cutting,12t. 7.Installed capacity of host machine:11.4kw, including hydraulic station. Main features of the cutting Machine: 1.The machine is simple and practical,easy to install andrepair 2.After tilting the blank stands vertically with the width of 600mm and the height of 1200mm,thus the cutting wire can be shorter and cutter precision can be more exactlyfor it is not easy to be broken and drifted. 3.The vertical cutting is done by the vertical cutting device (the blank is fixed on the table)while the horizontal cross--cutting device is driven by the screw which can ensure even lifting of the cross-cutting support and the cutting precision. 4.As the blank stands vertically, the grooves on both sides of the blank (with width of 600mm)can be milled at the timeof the blank cutting vertically, on groove processing device is needed. 5.The machine can process both building blocks and slabs and cut in six sides therefore the quality of product is free from affection of mould oil and the deformation of the mould. 6.The machine has simple operation and cutting processes (tilting,vertical cutting and cross cutting)can be finished in different positions plus that cutting and running are controlled in the same devicefor simplified operation and convenient maintenance.